TG module pinout

I have come across a new an very cheap TG module.

My plan is to open the case, remove the electronics, and fit them on a futaba module to use it on a FC28.
I already had a thread at the jeti/futaba subforum, where they think if should be possible as surely the electronics of TG and TF are the same and only the pin layout changes

jetiforum.de/index.php/13-futaba-jeti/13...ule-on-futaba#125269

Can someone let me know the pin layout of graupner modules?

Regards
Paco

I think the community here is too small regarding graupner infos
try rc-network or rc-groups
what you need is a community with in depths knowledge of the moduel trays in graupner JR transmitters
e.g. [strike]MX-20[/strike] X-347, X-388, X-3810ADT, X-9303, PCM-9X, PCM-9XII, PCM-10X, PCM-10S
and how the pins in the module tray are layed out, kind of reverse engineer the problem

__________

P.S.

or what about mailing jeti directly
they now for sure the pinout of the TG modul

Ok, I will follow your suggestion.

Think about it the other way round, imagine you have a jeti TF module, you want to use in a Graupner radio... the cable should be the same....

Hello
Google is your friend: graupner hf modul pinbelegung

very cool DanM thx !!!

so if I see it right according to this website:
tech.blog.dg4sfw.de/single.php?date=1219583220

the left image below is the pinout in the tray of an MX-22
the right image below shows the opened TG modul from Paco

and therefor the 3 pins Paco needs are VCC (red) GND (black) and SIG (yellow)

Hello,

I have found the pins for the futaba module at www.schiffsmodell.net/index.php?/forums/...sender-diy-in-fc-28/



If I am correct, and with the images Skyfreak added, the final connection should be:



Hope someone can verify and give me the GO.

If all is ok, I will get a spare futaba module box or print one with the 3d printer, fit the jeti connector, and make the cable to connect pins.... then cross fingers!