Receiver Output REX Assist in conjunction with a CB-Box

Hi Achim,

I don‘t think that this would make any difference. And I‘m not in a big mood to change the whole setup of my Piper

Ich glaube nicht, dass das einen Unterschied machen würde. Außerdem habe ich keine große Lust das komplette (tadellos funktionierende) Setup meiner Piper zu verändern.


Greets

Volker

The 900 in rx2 should not matter IF the CB setting is correct.  Volker, in the CB what switchover strategy have you set?  Mixing, or 80ms or 150ms?

80ms

I made the same experience as Volker. A workaround is, that you connect the "Light-Servo" to the RX900 (e.g. pin 3) and assign in the setup of the RX900 channel 16 to its pin 3. That should NOT affect the assignment in the central box as it does on the receiver connected as the "first" receiver to the central box.

Best regards, Kai

Hi Volker and Kai,

My equipment works correctly.  Changing pin 3 to channel 16 in the Rex12 assist made no difference in the CB, pin 3 in the CB still works on the original control.

Please contact Jeti and let them investigate it.

Hi Harry,

one question: Did You configure the assist to the end or just use it as a normal receiver?

For handing all this over to Jeti, may be one of the „Chiefs in command“ here in the Forum can help (PW? Ingmar? Jürgen?)

Volker