Lehrer/schüler - wireless trainer DC16 -> DC 16 with CB200 + 2x Rsat

Hello Jeti friends,

How to setup my DC16 transmitter as the instructor transmitter to a DC16 student transmitter, when using CB200 and 2x Rsat satelites ?

Thanks for any help.

Best regards from Denmark
Michael Buchreitz

Hello Michael,
to use two RX during Teacher / Student mode, you have to set one of the RX to "CLONE" mode.
Than you can use the secondary HF-Module to connect to the student TX.
The best way to switch to CLONE and later back to NORMAL mode is to use a physical Jeti-Box.

Ingmar

Hello Ingmar,

Thank you very much
Do you know if it's possible to change one of the recievers to 'clone' without having the Jeti-box box..?

Michael

Hello Michael,
yes, that's possible using the Jetibox-Emulation inside the Transmitter.
But it is much more complicate, as I know.
Sorry, but I did not have any experience, using the Jeitbox-Emulation, in this case.
All I know is, you connect the second RX to the first RX and than you can access the second RX thru the first one using the Jetibox-Emulator.

Ingmar

Hello Ingmar,

Very helpfull. Thanks:-)

I shall give it a try through the transmitter.

Michael

It's easy to switch the receiver to clone mode by the transmitter jetibox emulation. But it is not possible to switch back to normal mode by the transmitter directly as the telemetrie of the receiver is deactivated. There you need a physical jetibox.
In the past somebody in this forum showed a way to switch back to normal mode without a physical jetibox but i don't remember how.

edit: I found the thread with the solution
www.jetiforum.de/index.php/rex6-rex12/91...0-bindet-nicht#86896
You have to connect the cloned receiver to a second receiver and to reach it as sensor by the jetibox emulation.

Lukas