Software Update 6.03 für DC-24II und DS-24II

Is this the latest SW?



 

See my last post with the SW I have on my TX. 
I contacted Jeti and they expect next SW update will be end of July. 

Didier wrote: Is this the latest SW?

yes, 6.03.1832 is the latest.

 

Hi Didier,
in my case, it was DC24II with version 6.0, it failed to detect proper switch types at startup. If switch type was set to AUTO, it defaulted to 3-state switch type.
The issue occurred occasionally, depending on the charging state of the TX battery. The issue was linked to an unusual long boot time of 4 sec instead 1 sec.
Just in case, if you observe 4 sec boot time, it might be the same issue.
Alois

ahahn wrote: Hi Didier,
in my case, it was DC24II with version 6.0, it failed to detect proper switch types at startup. If switch type was set to AUTO, it defaulted to 3-state switch type.
The issue occurred occasionally, depending on the charging state of the TX battery. The issue was linked to an unusual long boot time of 4 sec instead 1 sec.
Just in case, if you observe 4 sec boot time, it might be the same issue.
Alois

Thanks. The 2 times it occurred was after charging. I have reconfigured the switch layout the first time I received the TX, but the TX recognize the different switches directly. The 2 times it happened, it was the RH side switches as you can see on the picture.

Hi Didier,
in may case it failed to auto-detect the switches. As a workaround I did not use the AUTO setting. When assigned a specific type, it worked.
As said, in my case the startup time was 4 seconds. This was because of a time-out of 4 seconds in the software when auto detct failed. It was a bug clearly, which was fixed very early at the DC24Ii. I wouldn't expect it for the DS24II any more.

Alois