Max servo travel limit not working with ail. diff.

  • PW
  • PW's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 9909
  • Thank you received: 3910

TPL_KUNENA_MESSAGE_REPLIED_NEW Max servo travel limit not working with ail. diff.

13 Feb 2014 14:57
#7
Hi,

normally not.

Was is the first programming of this aircraft ? Did you perhaps took the rates from your old TX ?


Regards

PW
Rechtsbeistand u.a. bei "Modellflugproblemen"etc. : Rechtsanwälte Wessels & Partner, Tel.: 02362/27065

PW Modellbautechnik ( Jeti Kombiangebote, Beratung/Einstellservice etc.)

Please Log in or Create an account to join the conversation.

  • Parakos
  • Parakos's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 8
  • Thank you received: 0

TPL_KUNENA_MESSAGE_REPLIED_NEW Max servo travel limit not working with ail. diff.

14 Feb 2014 09:06
#8
Yes this was the first programming, all done from scratch.

/Johan

Please Log in or Create an account to join the conversation.

  • PW
  • PW's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 9909
  • Thank you received: 3910

TPL_KUNENA_MESSAGE_REPLIED_NEW Max servo travel limit not working with ail. diff.

14 Feb 2014 09:35
#9
Hi,

I think the problems was that you took your rates from your old TX.

The Jeti TX makes more travel; for example:

If you have a Graupner radio with 90 % Dual Rate; than you will have the same travel from servo at the Jeti TX with 85 % Dual rate.

So normally you must minimize from Graupner to Jeti TX "Dual Rate" for about 15 % !


Regards

PW
Rechtsbeistand u.a. bei "Modellflugproblemen"etc. : Rechtsanwälte Wessels & Partner, Tel.: 02362/27065

PW Modellbautechnik ( Jeti Kombiangebote, Beratung/Einstellservice etc.)

Please Log in or Create an account to join the conversation.

Time to create page: 0.311 seconds
Powered by Kunena Forum