Double compensation during Butterfly landing dive

Hello !
I know it's possible to pilot with sticks ! but having a DS16 I would like to use all the power of the software but unfortunately I'm not so skilled.
Looking for an help.
I would like to have a double compensation on elevator during landing phase : when flaps reach full down position to contrast nose-up elevator down and after a while when nose is in down position to compensate in the opposite side. For the moment with Butterfly I've reached a good value for phase 1. After start to control "manually" via stick P2.

I tried with sequencer, but this take completely the control of elevator... and the problem is to have change in compensation from sec.4 to sec 11.....
Any idea? I hope what O've drawn it's clear to understand what i would like to do.

Sure I'm flying and landing manually, but again with DS16 power I think to reach a smoothest diving path .......
Thanks for your advices and comments.

Hello Miko,
"I tried with sequencer, but this take completely the control of elevator... "
If you like to test further in this direction, you should use the "Output" of the sequencer as an "Input" to a mixer.
Not allow the sequencer to control the servo directly.

Ingmar

Thanks. I shall try to use Q1 in a mixer Q1 to Butterfly if possible. Deleting elevator values in Butterfly and use Q1 output as an input.
Fine it's a possibility !

Hello Miko,
I think Q1 should be mixed to Elevator!
I thought the sequencer is used to control the elevator, right?
You can also upload the model file, than I can have a look.

Ingmar

Ingmar, I follow your order but I don't want you loose too much time for me !

here my model file.

Hello Miko,
there is no sequencer defined.
The model is quite complex, so it is not so simple for me to find out what you like to achieve.

Ingmar