Jeti Fuel Sensor released

Hallo zusammen hat schon jemand 1.3 oder sogar 1.4 getestet? Wir hatten es gestern getestet aber irgendwie machen wir was falsch 1.2 hat super funktioniert. Bitte um zahlreiche Antworten.


Mit freundlichen Grüßen
Thorsten

1.3 has new way of calibration. This is done because people can now use any flow-sensor with any pulse-count.
1.4 has memory added, requires digital output connected if "Dig.Reset" is set to "Yes" in setup.

Both have been tested with REX6 and R9 and work fine.

If you update from 1.2 you need to recalibrate with one liter (1000ml).

if my tank has only 300 ml how should I do that then.

Thorn wrote: if my tank has only 300 ml how should I do that then.

If you are using 1.4 (or 1.3) version you need to pump one liter (1000ml) as the webpage says HERE . You either take the senor out from model or move some tubes. This calibration method was a "must" to do because people wanted many different flow-modules with many different pulse-count per liter.

This is not a bad thing, in fact accuracy is spot-on when done this way.

okay 1 liter does not have to run with the engine. This is, of course, very difficult, but it is worth it. thank you

juhu it has now worked the way they said. I got out at 1000ml 26690. This is for a gasoline.

Yours sincerely thorn