Hallo "Joju",
sorry, Du kannst mir schon glauben, wenn ich es hier so poste... Alle EX-Empfänger mit der aktuellen Software können PPM ausgeben.
Siehe Empfänger-Manual FW3.11, Seite 15:
Output mode - setup for receiver output mode.
Servo - initial setup (except Rsat2 receivers); standard servo signals
are generated by the receiver outputs
PPM pos.*- setup of the standard form of PPM signal generation
with positive logic at PPM outputs (see the table of receiver output
assignments). The bus idle state is log. 0. All remaining receiver
outputs with exeption of the PPM output (see table of receiver
output assignments) will be disabled (there will be no servo signal
generated at the remaining outputs).
PPM neg.*- setup of the standard form of PPM signal generation
with negative logic at PPM outputs (see the table of receiver output
assignments). The bus idle state is log.1. All remaining receiver
outputs with exeption of the PPM output (see table of receiver
output assignments) will be disabled (there will be no servo signal
generated at the remaining outputs).
The receiver may be set-up in such a way, that its output will work in
digital communication form, which will be used as input by other
equipment.
Gruß
Henning
