User Interface -> Userdefined Function Curves

Hello Jeti Team,

I have just an idea for the usability of the function curves, which can be helpfull.

Today we have 4 basic funktion curves (3-points, 5-points, 7-points, 9-points). All the others are variations of the basic ones.

What I missed was a user defined curve with dynamic number of set points, but with a maximum e.g. of 9 points.
The position of the points will be set pushing the 3D-Control at a stick position. This means the user is moving the stick, e.g. throttle stick to a certain position and presses the 3d-control. Now the software will create the setpoint on the curve at the current position. The user can now move the set point up and down while rotating the 3d-control. Additional set-points on the curve will be created in the same way.

Selecting a point on the function curve can be proceeded on the same way. Selecting the point by moving the stick to the position of the setpoint, selecting it with the 3d-control and modifying it while rotating the 3d-control or using the F1-F4 buttons.

It is just an idea, which came in my mind after I was setting a 5 point function curve and needed 1 point more. I selected then the 7-point curve to get the additional point, but then the complete curve was reset and the programming started from scretch.

Maybe this can added to the DC16/DS16 firmware.

Thanks a lot and greetings

Joerg

I fully agree -
and this is a "Standard Feature" in some older transmitters - like the Graupner MX-24s and as a positive additional aspect - you always see the exact point of the curve as the stick is exact in the position you want to change the curve.
brgs,
harald

Hi,

Jeti software developer already has this on his "to do list" . ; but not comming with the next update.


Regards

PW

Hi Peter,

sounds good, hopefully this will be implemented within the firmware comming at Christmas

Greetz

Jörg