fail safe and ergonomy

for now the fail safe settings are stored in the rx . if you change the rx to an another model it is a pain in the neck to reset everything and do the new configuration. specialy if you have more models than Rx the day of the club demonstration .
I think an another way would be more secure, easier to do and to tune: to store the RX configuration data with the model in the Tx memory. on the switch on the Tx ask if you want to use this RX and if OK send the data to the Rx.
you can switch the Rx from a model to an another in a dream with no fuss an no risk. It is possible also to use a Tx switch to take a picture of the commands to use it as a fail safe position. no need to do hazardous thing to test the tuning of the fail safe, you fly like you want, flick a switch , bingo the fail sail is done.

as the las software update for the Rx enable the wireles configuration for the Rx I think the idea could be in the pipe already, if not, it could be a great idea.

thank a lot

Sorry,
Go to the device Manager and open the rx. (R9 example).
Press the F2 button and save the rx configuration with model name 1 to sd Card.
Now open Model 2 and do your configuration and save the rx configuration again with model name 2.

Now you can load the rx configuration each time you want.

At next time, no name no answer!!

With greets
Harald

HNAGL wrote: Sorry,
Go to the device Manager and open the rx. (R9 example).
Press the F2 button and save the rx configuration with model name 1 to sd Card.
Now open Model 2 and do your configuration and save the rx configuration again with model name 2.

Now you can load the rx configuration each time you want.
Harald

thank you a lot that's a nice feature

the possibility to record a position of the command during the flight to use it for the fail safe could be usefull and mor easy than to go in the jeti box menu to painfully set each channel .

HNAGL wrote: At next time, no name no answer!!

With greets
Harald

my name is just over the little head on the left , i didn't thought you could miss it

JF Pion (from cherbourg - france)

Hallo jf pion,
Update your rx to Firmware 3.23 or above.

Go to device Manager and open the rx (R9 example)
Now scroll down to Fail save menu and activate it.

Activate all Pins for Failsave Modus in the list below, puill your sticks and switches to preferred positions
and press the Fail-Save memory menu.

You don´t need the jeti box menu anymore for Fail safe settings!!

With greets
Harald

thank you a lot

look like the user manual need a rewriting, specially the french one
thank again

Hi,

please look always into the relaese notes of each update from TX or RX !


Regards

PW