DC16 FW5,06. Telemetrieverlust

IG-Modellbau wrote:

Hallo Yves,
in Lua kannst Du die Q-Werte auslesen:

system.getTxTelemetry ()
This function retrieves the system voltage, signal quality etc.
Parameters
none
Return value
 (table) - table containing basic transmitter and receiver telemetry data:
o "txVoltage" – transmitter voltage [V]
o "txBattPercent" – remaining battery capacity in percent
o "txCurrent" – transmitter current [mA]
o "txCapacity" – battery capacity (charged/discharged) [mAh]
o "rx1Percent" – signal quality of the primary receiver [%]
o "rx1Voltage" – primary receiver voltage [V]
o "rx2Percent" – signal quality of the secondary receiver [%]
o "rx2Voltage" – secondary receiver voltage [V]
o "rxBVoltage" – backup (900MHz) receiver voltage [V]
o "rxBPercent" – signal quality of the backup receiver [%]
o "photoValue" – raw value of the light intensity sensor (range from 0 to 4096)
o "RSSI" – a signal strength indicator (table). Higher value means stronger signal. The table values are specified in the following order:
 Antenna 1 of Rx1,
 Antenna 2 of Rx1,
 Antenna 1 of Rx2,
 Antenna 2 of Rx2,
 Antenna 1 of backup Rx,
 Antenna 2 of backup Rx.
Note: Some of the telemetry values are not available in DC/DS-16.

Ingmar