unable to open configuration on bootup

after applying the newest update i received an unable to read sd card and then unable to open configuration

it shows the tx sticks, then goes to switches and then into normal operation...

every time it boots it now says unable to open configuration.... the sd error was only the first time..

any thoughts? am i missing a config file it requires??

i tried reupdating the same thing..tried older versions the same thing....

Hi,

first check if you still have the calibration file in the Config folder !!!!!!!


If YES try this:

- remove SD card out of TX (not via USB ! OUT OF TX PLEASE)

-make SD card completly emty

-format SD with FAT 32

- then - out of the TX ! - copy all from new 1.06 update to the SD card

- then put SD card in the TX

- turn ON the TX


Regards

PW

i tried that..

format micros sd card
put 1.06 on it
started tx...

found update
applied update
restarted
sd card read error
unable to open configuration.... shows transmitter in graphic...can continue past it...
now every time restart no sd error but still unable to open configuration

redid calibration and it resolved the issue..must have created the missing file

This is correct because if you have an empty SD card, new files Config/Config.jsn and Config/Calib.jsn have to be created - it needs you to reassign system audio files, system volume and configuration. And of course perform new calibration.