Rsat2 linked to REX10 dual path or Clone ?

Hello,

the Jeti website seems to indicate that the Rsat2 can only work with the older R series.
I would like to connect a Rsat2 with a Rex10 in clone or dual path mode.
Is this possible?

There is a big discussion on the RCgroups Jeti forum concerning issues with UDI on the new REX receivers.
Not sure that this influences a PPM link, but differences in frame rate consistency are being reported between Dual path and normal mode.

Not sure what to make out of this to be honest, I am doubting now if my setup Rsat2 combined with a REX10 is a good idea.
Would it be better to use Clone mode rather then dual path (just seeking some additional RX antenna coverage)?

Thanks in advance for your reply

I had to manage the same Task and I connected my RSAT2 with a REX10 in dual path mode.

As far as I know, clone mode does not exist anymore in the latest firmware versions.

Dual path mode works as I expected.