Lipo battery used capacity

Hello all. Just searching for some help.
I'm using a dc16 as Tx, and in the model a WStech vario plus SM current sensor. Can get properly the motor current and battery used current showed on telemetry display. The question is the following: This would work OK on a single flight, but in my case,I may do several flights on the same battery charge and if I switch off the transmitter, the used battery value returns to "0" for the next flight. Is there a way to keep the value as may happen with the time (chrono) in order to program a used capacity alarm?
Jose

Hello,

on my SM Unisens-E i can configure, whether it should reset the used capacity or not.

I can select "fortgesetzt" (Unisens resets the capacity if a full battery is connected), "immer bei 0 starten" (Unisens resets after every disconnection and reconnection of a battery) or "immer weiter" (Unisens must be manually resetted).

I would look in the Manual of the SP current sensor or the WSTech vario.

Edit: See section 10.4 in the Manual of the LinkVario.

best regards

Wolfgang

Hi Jose,

this feature works automatically in the LinkVario. Only UniSense can be individually configured as mentioned before.
When using the SM current sensor the capacity will not be reset if the battery input voltage is in a range of 2% lower compared to the last flight value.To reset you need to switch off/on a second time with the same battery.

Best regards
Onki

OK, thanks a lot both... will give it a try...
Jose