sequence , automatic switch , or ....!?

Hello
I have DS 16 radio.
I will try to explain what I need :
I fly autogyros with a prerotator ( electric motor) which function is assigned to right proportional slider on the side .
For the moment , just before taking off I manually turn off the prerotator by moving back the slider .
I would like to have "automatic shut off" of the prerotator when I begin to move my throttle up ....
This is not possible with a mix because when I will move back the throttle to 0 , the prerotator will start again !
Thanks for advice of the pros , here , and explanation about how to make it , where to go , etc ....If this is possible
Best regards
Andre

André

Manual 9.2.5
I think you should try a solution by configuration of a 3 or 5 point curve. Same procedure as programming a curve for a smoke pump which starts and stops depending on the amount of throttle

Manual 9.1.7
For this you need a additional function (P1...2...3...4...prerotator) and then you should give him the signal by P4/throttle. After that try to mix the curve under section of the Curves.

I do not know exactly the meanings of all the wordings of the English manual

Hope this helps a little bit


Safe Flight's
Mauro

Hi Mauro
My problem is : I don't want the prerotator to start again when my throttle goes back to 0
I only want "one manual start" of prerotator with the slider and then a definitive stop when I move the throttle up to start flying .
No more start of prerotator once flying or landing
Thanks
Andre

Hello
Just for info , I succeded with b2 logical switches
Thanks for looking
Andre

hi andre

as others might want to profit from your experience/success as well, it is common sense in forums to give a detailed explanation how you succeeded.
(not for me btw, but in general)

imagine someone crawls the web for exactly that question, finds this thread, and then gets just the info that you succeede but not how
frustrateing isn't it, ya might have made this experience yourself maybe?!

so if ya find some spare minutes pls describe and take some screenshots what you did and how it works now for you.

cheers
guido

Hello
Here is the solution
pictures here :
rc.runryder.com/helicopter/rr/rrpv.htm?d...4/&IN=1&TZ=1&a=0&s=0
rc.runryder.com/helicopter/rr/rrpv.htm?d...4/&IN=2&TZ=1&a=0&s=0
rc.runryder.com/helicopter/rr/rrpv.htm?d...4/&IN=3&TZ=1&a=0&s=0
rc.runryder.com/helicopter/rr/rrpv.htm?d...4/&IN=4&TZ=1&a=0&s=0

Regards
Andre