REX10 and Rsat2 display

Hello,
I added an RSAT2 to a REX10 receiver on the E1 input, after the configuration everything is detected and seems to work. But when I test to deactivate the primary module or the secondary module I no longer have any indication on the antennas and no more voltage indications on the receivers. The servos continue to operate correctly. Is this normal I thought I had the information from the antennas which are still in operation.

THANK YOU


With deactivation 1 module primary or secondary


Without deactivation


REX10 and Rsat2

It's normal, but when you set the alarm to "Loss of both receivers" then you don't get an alarm in case one receiver is off, but you will see the remaining two antennas.

Regards, Walter

Hello, many thanks for your quick explanation.

Good flights 2021