Rex Assist

lufti wrote:
Es gibt eine Jeti Duplex " Update Aktion " Tausch von uralt Jeti mit 50 %

ohmgnohm wrote: Hat das Ding auch eine "Rettungsfunktion" ?

Stabilization of the horizon: Airplanes and Multicopters
Stabilization of the horizon is also suitable for beginners. In this case, the stabilization algorithm makes it possible to perform basic aerobatics, but if the pilot leaves the controls in the center position, the model is leveled to horizontal flight. For airplane models, keep in mind that it is necessary to maintain sufficient speed, as the Heading Hold mode is active at the same time.

Stabilize: Multicopters
The basic functions of the REX A receiver to stabilize the multicopter. The model is kept in a horizontal position during the flight, with the position of the controls indicating the pitch and roll angle of the multicopter. Maximum tilt angles can be defined in the Configuration - Advanced Properties menu, by default it is set to ± 45°. In this mode, altitude stabilization is not active, and there is no possibility of aerobatics.
Sport: Multicopters
This mode allows basic aerobatics even for multicopters, since the receiver only stabilizes the rotation speeds in individual axes and does not level the model to the horizontal flight. Altitude stabilization is also deactivated. The transmitter sticks control the rotation speed of each axis, the maximum speed can be defined in the Configuration - Advanced Properties menu (Max. roll/pitch/yaw rate).

Altitude stabilization: Multicopters
This mode is similar to the Stabilize mode, with the climb and descent rate being stabilized. The throttle position indicates vertical velocity. In the neutral position of the stick (which is around 1.5ms), constant altitude is stabilized. By adding the throttle, the model starts to climb.