R5L in clone en REX12A in default

Maybe it is a R5L issue. I don't have any normal R receivers. Anyway, I ordered a REX6 as this type of receiver works a least for me.

Hi,

I say no. Clone mode does only affects the receiver which is set to clone. So one RX can either be set too clone or not.

Setting to clone means this RX does not send any information back to the TX. Therefore the other devices can not know that there is an other RX listening.

You are doing something wrong.

regards

I know what you say and I understand the way clone system works. I have 2 jets with a clone system working perfectly. I have proved today that a combination of different RX works and other RX combination don't. All clone system procedures are the same so I guess I did not do anything wrong. You saw the first video and even Jeti says the procedure is correct.

You did something wrong. Try again step by step.

I have proven that the combination of R-RX with an Assist works. R-RX share the same hardwareand mostlikely the same basic firmware. When you can set your R5 to clone mode and it is working together with a normal REX sameapplies for an Assist since the clone is not communicating with the rest of the system.

Jetis comment reflects that Martin left Jeti and the new guys are doing their best ....

Hello!

Just a Guess...
Maybe it depends on which Firmware is installed on the RX?

If you have different results with the Same Hardware.

Regards
Nicolas

no,

he told us it works with a normal REX and not with an Assist. That is only possible if he does something wrong.